Used Miller Spoolmatic 15A MIG Welding Gun #195156

$805.00 $1,323.00 Reduced Price You Save $518.00
Product Number: 195156U

Used Miller Spoolmatic 15A MIG Welding Gun #195156

MIG welding is often very cumbersome and unwieldy. Having to feed the wire while also getting the exact weld can be troublesome, but this is not the case with the Miller Somatic 15A welding gun (#195156). Designed for the Millermatic 252 welding machine this gun has been specially engineered for comfort of use with the grip having ergonomic finger groves, and portability with many features of it having been streamlined for portability and ease of use. These features include such things as an interchangeable barrel for either Roughneck or Bernard Centerfire both being compatible with this gun making for an adjustable weld and length of the gun dependent upon need, an built in gas valve that completely eliminates the need for the user to purge the gas lines of long leads, and the spool canister is capable of rotating a total of 180 degrees allows for the user to be able to get the gun into tight locals without worry of the canister getting in the way and not reaching the desired weld location. These features make the gun easy to use while being of moderate, but quality size in order to get the job done when and how you need it to be. This however does not mean that the limited size of the unit increases the amount of time it takes to complete a job either. For the wire speed can be completely adjusted with a simple turn of a dial attached to the handle, and the drive roll itself being completely reversible to retract wire if the need arises saves you not only time on a job, but also money as well.

Welding Output Rating 200 A at 100% Duty Cycle
Wire Diameter Capacity .030 - 1/16 in (0.8 - 1.6 mm) aluminum wire and hard wire up .045 in (1.1 mm)
Wire Speed 70 - 875 IPM (1.8 - 22.2 m/min)
Max Spool Size Capacity 4 in (102 mm)
Net Weight 14 lb (6.4 kg) with cable assembly

SHIPPING DIMENSIONS

Height: 11.00 Inches
Width: 16.00 Inches
Length: 16.00 Inches
Weight: 4 Lb(s) 0 Oz

Product Questions and Answers

How to install gas supply:

  1. Secure gas cylinder.

    Obtain gas cylinder and chain to running gear, wall, or other staionary support so cylinder cannot fall and break off valve.

  2. Clean out gas valve.

    Remove cap, stand to side of value, and open valve slightly. Gas flow blows dust and dirt from valve. Close valve.

  3. Install.

    Install so face is vertical.

  4. Adjust flow.

    Typical flow rate is 20 CFH. Check wire manufacturer's recommended flow rate.

  5. Close flow adjust.

    Make sure flow adjust is closed when opening cylinder to avoid damage to flowmeter.

  6. Install adapter.

    Install adapter with O-ring between regulator/flowmeter and CO2 cylinder.

Have a question about this product? Submit your question using the form below

* required

People who bought this product were also interested in: