Miller Intellx Basic 12’ Dual Swingarc Wire Feeder #301557

The Intellx Basic 12’ Dual Swingarc wire feeder by Miller is the ultimate shop addition for those welders looking to maximize their work area. 360-degree rotation, a 60-degree lift angle and a 12-foot boom arm allow you to position the dual wire feeders wherever necessary. In-boom cable routing makes organization easier and clears up even more work space.

Meets NEC requirements

Meets NEC requirements when properly installed and utilizing recommended primary circuit protection and proper fuse selection for primary power applied to rack.

Fuses meet IP-20 finger safe rating

Fuses meet requirements of IEC 60529 for IP-20 finger safe rating. Miller inverter racks are the only racks on the market to provide IP-20 finger safe rated fusing.

Simple Fuse holders

Fuse holders are designed to accommodate fuses for both 300 A (208–575 VAC) and 450 A (380–575 VAC) inverters in all voltage ranges applicable to power source.

Optional Running Gear

All racks can be equipped with optional running gear. The large five-inch diameter wheels enables the rack to be moved over grating and driveway gravel.

Check out our selection of welders and welding equipment from Miller and other brands.

Product Literature

• Miller XMT Racks - Spec Sheet (English)

General Specifications

• Miller XMT Racks - Spec Sheet (English)

Product Questions and Answers

Have a question about this product? Submit your question using the form below