Hypertherm Powermax 30 Air Nozzle #420134
The best work is done with the best tools and parts. You need strong, durable parts in working order to complete your project as effectively and efficiently as possible.
The Hypertherm nozzle #420134 is designed specifically for the Hypertherm Powermax Air 30 plasma cutter (#088096).
Hypertherm is as good as it gets when it comes to providing high quality products at a low price. Their nozzles prove durable and reliable even with extensive use.
Keep a close eye on the consumable parts on your hand-held welder. As they degrade from heavy use, they wear and compromise your tool’s performance.
- Check the nozzle for an enlarged or misshapen hole.
- If the nozzle cannot properly restrict gas flow, it cannot effectively control the width of your cut.
- Keep them clean—pick up a 5-pack of these Hypertherm nozzles and keep your welder cutting clean.
The nozzle (Part #420134) specifically designed for the Hypertherm Powermax Air 30 plasma cutter (Part #088096) is made of the most durable and effective materials for the job as possible. Check your nozzle often to see if the hole has enlarged or become egg shaped. That will cause poor arc starts and poor cut quality. In General change your Electrode and Nozzles out at the same time.
This nozzle is designed to restrict the flow of the plasma, effectively controlling the width of your cut. So change those nozzles in time folks and your keep your cuts nice and clean!