Miller S-74 MPa Plus Wire Feeder #300577
The Miller® S-74 MPa Plus single wire feeder is capable of synergic pulsed MIG Welding and can carry up to 4 separate welding programs easily retrieved for a faster setup. This single wire feeder is also optimized for use with XMT™ MPa and Miller Invision™ MPa welders. It is also capable of operating with Miller push-pull aluminum MIG guns along with having adjustable weld sequence control.
Capable of remote voltage control, the Miller® S-74 MPa Plus single wire feeder comes with a digital volt and wire feed speed meters (amp). This heavy industrial, four drive roll, 24 VAC wire feeder for MIG and flux-cored welding wires feeds 0.23 to 5/64 diameter welding wire anywhere from 50-780 inches per minute. Coming standard with a trigger hold, dual tension control, adjustable run in and tool-less rotatable drive, the floating positive drive system provides consistent feeding of an array of welding wires.
- Alumination™ technology gives you the ability to use the extended reach of a push-pull system for consistent, versatile and dependable aluminum wire feeding
- Alumination gives you the versatility to handle whatever aluminum welding job you want to tackle
- Synergic Pulsed MIG operation when optimized with the Invision MPa power supplies
- Provides communication between the power source, feeder and gun
- As wire speed increases/decreases, the pulse parameters also increase/decrease to match the right amount of power needed
- Trigger schedule select allows the operator to select the alternative schedule by quickly tapping the gun trigger when not welding
- When optimized with MPa power sources the operator can also switch from MIG to Pulsed MIGProfile Pulse™ provides TIG appearance with MIG simplicity and productivity
- Achieve “stacked dime” weld bead appearance without back-stepping
- Profile Pulse frequency can be changed to increase or decrease the spacing between the ripple pattern to achieve the desired weld appearance
- Accu-Mate™ properly seats the power pin for best feeding performance and prevents Accu-Mate grooved MIG guns from sliding in the cast
Welders Supply carries the best welding equipment. Shop online now!
- MIG (GMAW)
- MIG (GMAW-P)
- Flux Cored (FCAW)
- (Gas- and Self-Shielded)
|Input Power:||24 VAC, 10 A, 50/60 Hz|
|Wire Feed Speed:||50 - 780 IPM|
|Wire Diameters:||.023" - 5/64"
.035" - 1/16" Aluminum
|Dimensions (Single Feeder):||H: 14" (356 mm) W: 12.5" (318 mm) L: 28" (711 mm)|
|Weight (Single Feeder):||58 lb (26 kg)|
|Dimensions (Dual Feeder):||H: 14" (356 mm) W: 21" (533 mm) L: 35" (889 mm)|
|Weight (Dual Feeder):||
87 lb (39.5 kg)
|Weight:||60 Lb(s) 0 Oz|