Miller Used S-74 DX FEEDER #300618
The dual schedule allows the operator to switch between two welding parameters without readjusting the machine, eliminating downtime and enhancing the quality of work. The adjustable weld sequence control gives the operator complete control of the welding parameters: preflow, run-in, weld time, crater burn back and postflow.A welding process range control locks parameters at a set percentage of welding parameters to ensure welding procedures and quality standards are maintained on the shop floor. Four weld programs allow the operators to store four independent welding parameters reducing welding setup time
(H X W X L): 14" X 12 1/2" X 28"
Machine Model S-74DX
Physical Size 14" X 12 1/2" X 28"
Input Power 10 AMP, 24 VAC, 50/60 Hz
Weight 58 lb
Power Source Requirement CV - Constant Voltage
MIG Wire Size .023" - 1/8" Carbon Steel
Wire Speed IPM 50 - 780 in/min
Suggested Power Source DeltaweldSeries, Dimension NT 450, Dimension Series, Invision Mpa, XMTMpa Series, XMTSeries
Wire Type Carbon Steel
|Weight:||60 Lb(s) 0 Oz|